stabo xm 3006e VOX 12/24 Bedienungsanleitung Seite 23

Press the transmit/PTT key 11 or one of the keys 6, 7 or 8 to stop scanning. The dot between
the two channel digits disappears from the display.
Note: Please observe the StVO (highway code).
Setting the -5 KHz carrier offset in RU mode
In RU (rU) mode, T0 (t. 0 ) is the standard setting.
To enter the carrier offset setting, press and hold the F key until T5 (t5) appears, then release.
To return to the standard setting, press the F key again until T0 (t. 0 ) appears, then release.
Signal level
The bar display to the left of the channel display indicates the signal level in S levels when
receiving. S-values of 3, 5, 7 and 9 are displayed.
Transmitting
To transmit, press the PTT key (push-to-talk key) 11 on the left-hand side of the microphone
and speak into the microphone at a normal volume while you hold the key. Do not speak too
loud. This way your voice will sound natural on the outstation. It is advisable to try it once
and receive a modulation report. Please do not forget that you should not transmit without a
connected and tuned antenna as your radio device will otherwise become damaged.
Wait for a moment before you begin transmitting in order to hear whether the channel is free
so that you do not "double-up" with another station. Also bear in mind that the transmitter
takes a certain amount of time to start up. Therefore, do not start talking immediately but
rather wait for a second.
TOT (timeout timer)
If the PTT key remains pressed for longer than 3 minutes, the transmission ends automatically
and the channel display flashes.
Power display
When you press the PTT key, the bar display indicates the relative output power of the
transmitter instead of the S-value. In AM mode more or fewer bars are displayed depending on
the modulation.
Colour of the background lighting
This function allows you to select the colour of the display background lighting.
1. Switch on the device while pressing the MODE key 8 at the same time. The letters
associated with the current colour flash.
2. Turn the rotary switch 4 or press the UP/DN keys 12 on the microphone to select the colour.
The 7 colours available are displayed one after the other:
orange
Or
3. Press the transmitter/PTT key 11 to confirm and exit. If the key acknowledgement tone is
activated, a long acoustic signal confirms that the operation was successful (see section
key acknowledgement tone on page 21).
4. If a key hasn't been pressed for 5 seconds, the device exits the colour setting automatically
without saving the setting.
The default colour is: Or (orange).
green blue
gr BL
cyan yellow
C e
23
violet light blue
pU CL