15.1.1 Starting the Machine
For the machine to be started, the E
must be unlocked and the belt cover and spindle guard must
be closed!
Press the O
key (b).
N
15.1.2 Stopping the Machine
Normal stop:
- Press the O
button (c).
FF
In an emergency:
- Switch off by pressing the E
15.1.3 Setting the Speed
Set the speed with the speed lever (e).
ONLY WHEN THE MACHINE IS RUNNING!
Read the speed on the speed display.
The smaller the bore, the higher the rotational speed.
To achieve a good result also applies:
Soft material =>high speed
Hard material => low speed
15.1.4 Setting the Drilling Depth
Bring the drill depth stop (f) into the desired position.
Read off the drilling depth on the drilling depth scale
(g).
15.1.5 Clamping the workpiece
Do not attempt to secure the workpiece to be
machined by hand against entrainment by the drill.
Secure the workpiece to be machined by clamping it.
Use a machine vice or clamping claws to clamp the
workpiece.
15.1.6 Adjusting the Height of the Worktable
Adjust the height of the drilling table so that the
distance between the drill tip and the surface of the
workpiece to be machined does not exceed 5 mm.
HOLZMANN MASCHINEN GmbH
N O T E
S
MERGENCY
TOP
www.holzmann-maschinen.at
S
switch (a)
MERGENCY
TOP
switch (a).
OPERATION
26
SB163VH