Operation - HOLZMANN-MASCHINEN SB 163VH Betriebsanleitung

15

OPERATION

 Always disconnect the machine from the power source and secure it against
unintentional reconnection before carrying out any conversion or adjustment
work!
 When drilling workpieces with uneven surfaces, use suitable support pads!
Never start the drilling machine with the drill pressed down!

 Before each use, check that the safety devices are in perfect condition.
 Check the screw connections for tightness at least once a week.
 Regularly check that the warning and safety labels on the machine are in
perfect and legible condition.
HOLZMANN MASCHINEN GmbH
W A R N I N G
C A U T I O N
N O T E
www.holzmann-maschinen.at
6. Mounting the lever for setting the drilling
spindle speed.
Tighten the lever for setting the drilling
spindle speed.
7. Mounting the spindle guard
 Fasten the spindle guard cover with
two screws to the bracket.
 Push the spindle protection holder
through the switch housing.
 Fix with hexagon socket screw and
spacer washer.
8. Mounting/removing the drill chuck
 Degrease all parts.
 Use a rubber hammer to fix the drill
chuck with a careful blow (1
far left).
 To remove the drill chuck again, extend
the spindle and turn it until you can
attach the drift wedge.
 Remove drill chuck with a careful blow
(2nd picture left).
OPERATION
st picture
25
SB163VH