Assembling The Machine - HOLZMANN-MASCHINEN SB 163VH Betriebsanleitung

Voltage
220 V – 240 V
50 -60 Hz
Please note that work on electrical components or equipment may only be carried out by a
qualified electrician or under the direction and supervision of a qualified electrician!
The following also applies in connection with the electrical connection:
 The connector plug, if present, must not be tampered with.
 The earthing conductor is yellow-green.
 The power supply mains must be fused with 16 Ampere.
 Check whether the mains voltage corresponds to the requirements of the machine.
 After the electrical connection, check the correct running direction (3 phases).
 Make sure that any extension cable is in good condition and suitable for power
transmission. An undersized cable reduces power transmission and heats up
considerably.
 Replace damaged cables immediately!

14.2 Assembling the machine

The machine has been dismantled for transport purposes. For assembly please observe the
following assembly instructions:
HOLZMANN MASCHINEN GmbH
Extension
www.holzmann-maschinen.at
<27 m
<44 m
<70 m
<105 m
1. Mounting the column
2. Place the column on the base plate so
that the holes match the threaded
holes.
3. Fasten the column with screws.
4. Mounting drilling table and crank handle
 Mount the drilling table and height
adjustment crank (as shown in the
illustration on the left).
5. Mounting machine head and spindle stroke
lever
Place the machine head on the column and
fix it with hexagon socket screws (a).
Mount the spindle lift lever.
ASSEMBLY
Strand Cross-Section
1,5 mm 2
2,5 mm 2
4,0 mm 2
6,0 mm 2
SB163VH
24