auna 10032295 Bedienungsanleitung Seite 25

Manual tuning
1. Switch on the unit by pressing the On/Standby button (2), then press
Function button (8) to select " FM " mode.
2. Tune to the required station by pressing the Skip up
button (10)
3. Press the Volume knob (3) to the desired volume level.
Radio data system (RDS)
This is the features to display the information which released from the
radio broadcast and will showed on LCD display step by step as below by
pressing the Stop button (11) continuously: Radio text > program type >
signal strength > Date/time > frequency > mono/stereo.
Preset stations
You can store up to 40 radio stations in the memory (20-FM/20-DAB).
1. Set to FM/DAB mode
2. Turn to the desired radio station by " manual " or " auto " tuning
method.
3. Press and hold the +10/MEM/Pre button (12) around four seconds to
enable memory state, the preset station memory number will flash on
LCD display.
4. Preset the Skip up
station memory number for storage.
5. Press Enter/Play mode button (13) to confirm the preset memory. The
display will show "Preset * restored". (* meaning the station memory
number)
6. Repeat step 2 to 5 to store other stations.
Recall preset stations
1. Press the +10/MEM/Pre button (12) once and press Skip up
button (10) to select the desired memory station.
2. Press the Enter/Play mode button (13) to confirm the recall memory
station.
Note: The pre-set memories will be cancelled completely if dis-
connecting the main power. You are recommended to switch the system
into standby mode for convenience usage. There are 3 seconds for
program state, after 3 sec. This state would resume to normal tuner
mode automatically. You can overwrite a present station by storing
another frequency in its place.
/down button (10) to select the desired
/down
/down
EN
25