Inhaltsverzeichnis
Werbung
Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must remain
present and clearly legible throughout the entire lifetime of the product. Immediately replace or repair illegible
or damaged signs, symbols and instructions. Contact your local dealer for instructions.
Caregiver
•
Read the "User Guide" carefully before use
EN
and keep it for future reference. Incorrect use
of this product may cause serious injury to the
user
•
Always use the correct lifting techniques and
aids for this purpose
•
Never leave the user unattended in this
product. Ensure permanent supervision by an
adult
•
Repair/replacements must only be made using
new original R82 spare parts and fittings and
carried out in accordance with the guidelines
and service intervals prescribed by the supplier
•
If there is any doubt as to the continued safe
use of your R82 product or if any parts should
fail, stop using the product immediately and
contact your local dealer as soon as possible
•
Always use the product in a moderate pace. Do
not run with the product
•
When adjusting the seat angle, keep a hand
on the seat mounted on the frame to ensure
slow angling
•
Ensure that moving parts does not squeeze or
trap body parts when adjusting them
•
Information about transportation can be found
in the document "Transportation in Motor
Vehicles" supplied with the product
•
Information about roadability can be found in
the document "Roadability" supplied with the
product
•
Information regarding frame and seat
combinations including max. load in
combination can be found at: support.r82.org
Environment
•
Observe the surface temperature on the
product, before placing an user in it. This goes
especially for users with insensitive skin as they
cannot feel the heat. If the surface temperature
is above 41°C then allow the product to cool
before use
•
Use this product on a level surface without
any obstacles. Be aware of reduced
maneuverability on slippery surfaces
•
When using on inclines, please refer to
measurements
Environmental conditions
•
Operating temperature: 5°C to +40°C
•
Storage temperature: -10°C to +50°C
•
Relative humidity: 5% to 90%
•
Atmospheric pressure: 800 to 1060 hPa
User
•
If the user is close to the max. load limit and/
or has a lot of involuntary movements, e.g.
rocking, a larger size with a higher max. load or
a different R82 product should be considered
•
For transportation the product is suitable
for children in the weight range of 22 kg to
specified max user weight for transportation
•
Do not place more than one user in the product
Product
•
Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of the
reach of children
•
Activate the brakes before placing the user into
the product
•
Ensure the stability of the product is
maintained before placing the user in it
•
When the footplate is close to the floor and the
castors, the castors may be unable to swivel
•
If the frame has to be used in the lowest
position, Remove the footrest before
adjustment.
•
The frame with power does not have a safety
stop. Make sure that the foot support bar does
not collide with the cross bar on the frame on
High Low:x size 3
•
Inspect the product and all of its accessories
and replace any worn out parts before use
•
Do not expose the gas spring to pressure or
high temperatures. DO NOT puncture
•
Do not expose the piston rod to scratches etc.
It is important to use a cloth or the like, if tools
are used to adjust the gas spring
•
When mounting a Panda Futura seat size 4 on
any High Low or High Low:x frame, you must
mount the anti-tip device that comes as an
accessory to the product
30
support.R82.org
Werbung
Inhaltsverzeichnis
