Getting To Know The Appliance; Electrical Connection - Bosch KGV24320 Gebrauchsanweisung

EN.qxd 30/10/02 13:08
EN
Getting to know the
appliance
Before starting to read, please open out the
pages containing the photographs at the back
of this booklet.
This Instructions Manual applies to various
models. It is possible therefore that some of
the details shown on the photographs do not
correspond exactly to your particular model.
Parts of the appliance
Figure a
2
3
4
5
6
7
8
9
11
12
13
14
15
16
22
A
B
16
Página 16
Temperature selection control
and interior light.
Storage shelves
Rear wall of the appliance
(chilling)
Drainage duct
Drainage outlet
Glass shelf
Vegetable drawers
Egg tray
Butter container
Rack
Bottle rack
Freezing drawers
Chart showing storage periods
for frozen products.
Ventilation grills
Switch (Fig s)
Refrigerator compartment
Freezer compartment
Installing the Appliance
Location for installation
The most appropriate place for installing the
appliance is in a dry, easily ventilated room.
Avoid placing the appliance in a position where
it is exposed to direct sunlight or close to a
source of heat, eg. electric oven or
cooker, radiator, stove etc. If it is unavoidable
that the appliance is installed near a source of
heat, fit suitable insulation or respect the
minumum distances set out below:
3 cm between the appliance and an electric
cooker.
30 cm between the appliance and oil- or
coalfired ranges or ovens.
If the appliance is to be installed next to
another refrigerating unit, ensure that there is a
minimum distance of 2 cm between them in
order to avoid the formation of condensation.
Installing the appliance and
Changing the Opening
Direction of the door
Please see the Installation and Modifications
Manual

Electrical connection

The appliance must only be connected to an
alternating current of 220-240 V/50Hz. Ensure
that the base of the plug socket is installed in
accordance with the norms in force and fit a 10
amp fuse or automatic cut-off switch.
Ventilation
Ensure that the hot air emitted from the rear of
the appliance may escape freely. This avoids
the condenser having to work harder and
prevents excessive electricity consumption.
Therefore, ensure that the ventilation grilles are
not obstructed in any way, and never cover
them.