Medtronic MINILINK REAL-Time Bedienungsanleitung Seite 13

in water or any other cleaning agent. If liquid gets inside the black
connector of the tester, shake the liquid out and allow to air dry.
For single-patient use
1 Use a damp cloth with mild cleaning solution, such as Dial
Dishwashing detergent, to clean any dirt or foreign material from
the outside of the charger or tester. Never use organic solvents
such as paint thinner or acetone to clean the charger or tester.
2 Apply three to four drops of a quaternary ammonium compound
disinfectant (for example, Cavicide
wipe all the surface areas of the charger or tester.
3 Slightly dampen a clean cloth with isopropyl alcohol and wipe all
the surface areas of the charger or tester.
4 Place the charger or tester on a clean, dry, non-shedding cloth
and allow to air dry.
For multiple-patient use
Warning: Always clean the MiniLink after removing it from the patient
and before attaching it to the charger. If blood comes in contact with
any surface areas of the charger or tester, the contaminated device
must be discarded. The charger contains a battery which may explode
upon incineration.
Caution: Dispose the charger according to the local regulations for
battery disposal (non-incineration).
Follow this procedure to clean the charger or tester after each patient
use.
1 Use a damp cloth with mild cleaning solution, such as Dial
Dishwashing detergent, to clean any dirt or foreign material from
the outside of the charger or tester. Never use organic solvents
such as paint thinner or acetone to clean the charger or tester.
2 Apply three to four drops of a quaternary ammonium compound
disinfectant (for example, Cavicide
wipe all the surface areas of the charger or tester.
) on a clean, dry cloth and
®
) on a clean, dry cloth and
®
- 11 -
®
®