Agilent Technologies U1401A Schnellstart Handbuch Seite 4

N O T E
Constant Voltage and Current Outputs
Constant voltage output
1 Set the rotary switch to any
one of the positions.
2 Press . The
annunciator appears.
3 Press to cycle through
±1.5 V, ±15 V,
±15 V,
±15 V output modes.
4 Select ±1.5 V or ±15 V.
5 Press
to output the
signal.
Autoscan and autoramp outputs
The voltage and current outputs can also be generated in predefined steps or ramp. Refer to
the User's and Service Guide for the detailed procedures.
Square Wave Output
1 Set the rotary switch to
2 Press
. The
annunciator appears.
3 Press to cycle through
the adjustment modes for
frequency ( ), duty cycle
( ), pulse width (
amplitude ( ). Select a
parameter to adjust.
U1401A Quick Start Guide
The U1401A can generate and measure signals simultaneously. While the
enabled, pressing
mode ( ). Pressing OUTPUT again toggles the output on (
±1.5 V,
±1.5 V, and
.
), and
disables the U1401A output by placing it in the standby
Constant current output
1 Set the rotary switch to any
one of the
2 Press
annunciator appears.
3 Press
±25 mA,
4 Select ±25 mA.
5 Press
signal.
4 Press
parameter value.
5 Press
square wave signal.
mode is
).
positions.
. The
to cycle through
±25 mA, and
±25 mA output modes.
to output the
or to adjust the
to output the