Denon dvd a11 Bedienungsanleitung Seite 7

(2) Connecting to a TV or Monitor Equipped with Color Component Input
Connectors
Color component output connectors (P
The red (P /C ), blue (P /C ) and brightness (Y) signals are output independently, achieving
R R B B
more faithful reproduction of the colors.
• The color component input connectors may be marked differently on some TVs or monitors
(P , P and Y/R-Y, B-Y and Y/C , C
R B R
instructions.
• Connect in this way if your TV is compatible with Progressive Scan.
DVD-A11
TV
Y P /C P /C
B B R R
COMPONENT VIDEO IN
NOTES:
• Use the three commercially available video cords to connect the DVD-A11's color component output
connectors to the TV or monitor.
• Set the "TV TYPE" in "VIDEO SETUP" in "SETUP" to comply with your TV's video format. When the TV
is PAL formated, set to PAL. (See page 18.)
• Set the "VIDEO OUT" in "VIDEO SETUP" in "SETUP" to comply with Progressive TV.
• To use with 2-channel audio output, set "2 CHANNEL" in "AUDIO CHANNEL" in "AUDIO SETUP" in
"SETUP" at the initial settings. (See page 19.)
• Set the "TV ASPECT" in "VIDEO SETUP" in "SETUP" to comply with your TV's aspect. (See page 18.)
CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COMPATIBLE
WITH THIS PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF
525 PROGRESSIVE SCAN PICTURE PROBLEMS, IT IS RECOMMENDED THAT THE USER SWITCH THE
CONNECTION TO THE "STANDARD DEFINITION" OUTPUT.
/C , P /C and Y)
R R B B
and Y, etc.). For details, refer to the TV's operating
B
To power outlet
L R
AUDIO IN
(3) Connecting to a TV with 21-pin SCART Terminal (For only European model)
• Use the commercially 21-pin SCART cable to connect the TV's 21-pin SCART terminal to the DVD-A11's 21-
pin SCART terminal (AV1 / AV2).
TV
DVD-A11
• Some discs contain copy prohibit signals. If such
discs are played via a VCR, the copy prohibit
system may cause disturbance in the picture.
• To improve picture quality, you can change the video signal output from the AV1 terminal from "Video" to
either "S-Video" or "RGB" to suit the type of television you are using (See page 18).
• You can also connect other equipment to AV2.
This unit
AV1
SCART terminal
of TV set
AV2
NOTES:
• Set the DVD-A11 to the standby mode to output video or audio signals of another device connected to the
DVD-A11's 21-pin SCART terminal.
(If the power is on, the DVD-A11's video and audio signals are output. If the power is off, the signals of
the other device will not be output.)
• To use the 21-pin SCART terminal, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "2
CHANNEL".
21-pin SCART terminal
To power outlet
NOTES:
• Set the "TV TYPE" in "VIDEO SETUP" in
"SETUP" to comply with your TV's video format.
When the TV is PAL formated, set to PAL. (See
page 18.)
Satellite receiver
Video cassette recorder or decoder
AV1 VCR
AV2
ENGLISH
7