Optional Accessories - Makita HR4003C Bedienungsanleitung

Fig.22
(For model HR4003C, HR5202C) Loosen the six screws
and remove the handle.
Fig.23
Fig.24
(For model HR4013C, HR5212C) Loosen the eight
screws. And remove the guard cover as shown in the
figure. And then remove the handle.
Fig.25
Remove the connector by pulling it.
Fig.26
Loosen the screws and remove the change lever.
Remove the crank cap cover.
Fig.27
Remove the control plate.
Fig.28
Loosen the six screws and remove the crank cap. Rest
the tool on the table with the bit end pointing upwards.
This will allow the old grease to collect inside the crank
housing.
Fig.29
Wipe out the old grease inside and replace with fresh
grease:
For model HR4003C, HR4013C: 30g
For model HR5202C, HR5212C: 60g
Use only Makita genuine hammer grease (optional
accessory). Filling with more than the specified amount
of grease can cause faulty hammering action or tool
failure. Fill only with the specified amount of grease.
Reinstall all removed parts.
Fig.30
Attach the connector and reinstall the handle.
NOTE:
Note that the different lengths of screws are used.
NOTICE
Do not tighten the crank cap excessively. It is
•
made of resin and is subject to breakage.
Be careful not to damage the connector or lead
•
wires especially when wiping out the old grease or
installing the handle.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
SDS-MAX Carbide-tipped bits
•
SDS-MAX bull point
•
SDS-MAX cold chisel
•
SDS-MAX scaling chisel
•
SDS-MAX clay spade
•
Hammer grease
•
Bit grease
•
Side handle
•
Side grip
•
Depth gauge
•
Blow-out bulb
•
Safety goggles
•
Carrying case
•
Dust extractor attachment
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
9
or attachments
Only use accessory or
are