Remote Control; Button Description - Sony FWD-32B1 Bedienungsanleitung

Remote Control

Note
You cannot use the S VIDEO button, button, the OPTION1 button and the OPTION2 button on this display.

Button Description

1 ON (power-on) button
Press to turn the display on.
Operate when the main power switch on the rear of the display is
"ON."
2 DVI button
Press to select the signal input to the DVI port.
3 HDMI button
Press to select the signal input to the HDMI IN connector from a
piece of video equipment.
4 VIDEO button
Press to switch between the input signals from VIDEO IN and
COMPONENT IN
5 PICTURE button
Selects "Picture Mode". Each press toggles between "Vivid",
"Standard", "Custom", and "Conference".
6 F/f/G/g/
Press the
the values.
Pressing
7
Press to change the aspect ratio (page 18).
8 MENU button
Press to show the menu on the screen. Press again to hide the menu
(page 22).
Notes
• The 5 button and button have a tactile dot. Use the tactile dot as a reference when operating the display.
• Insert two size AA (R6) batteries (supplied) by matching the 3 and # on the batteries to the diagram inside the remote control's
battery compartment.
Caution
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the
manufacturer. When you dispose of the battery, you must obey the law in the relative area or country.
Push and slide to open
16 GB
buttons
F/f/G/g buttons to move the selected menu item and set
sets the selected menu or setting items.
button
,