Important Safeguards - Redmond SkyKettle RK-M173S-E Gebrauchsanleitung

Carefully read all instructions before operating the appliance and save them for
future reference. By carefully following these instructions you can considerably
prolong the service life of your appliance.
The safety measures and instructions contained in this manual do not cover all
possible situations that may arise during the operation of the appliance. When op-
erating the device the user should be guided by common sense, be cautious and
attentive.

IMPORTANT SAFEGUARDS

• The manufacturer is not responsible for injuries
caused by failure to comply with the safety re-
quirements and operation rules of the appliance.
• This appliance is intended to be used for nonin-
dustrial use in house hold and similar spheres of
application. Industrial application or any other
misuse will be regarded as violation of proper
service conditions. Should this happen, manufac-
turer is not responsible for possible consequences.
• Before plugging in the appliance ensure that the
circuit voltage matches operating voltage of the
appliance (see the technical specifications or the
manufacturer' s plate on the appliance).
• Use an extension cord designed for the power
consumption of the appliance as the parameter
6
mismatch may result in a short circuit or a fire
outbreak.
• Use only earthed electric sockets as this is an
obligatory safety requirement. Use an earthed
extension cord as well.
• Unplug the appliance after use, while cleaning
or moving. Remove the power cord with dry hands
holding it by the plug, not cord.
CAUTION! Appliance runs hot while operat-
ing. Do not touch the housing while the ket-
tle is operating. Do not lean over the appli-
ance when the lid is on to avoid scalds. The
heating element surface is subject to re-
sidual heat after use.
• Use the appliance for its intended purpose only.
Do not misuse to avoid potential injury. Avoid
spillage on the connector.
• The kettle is used only with a specially designed
base (included).
• Do not place the cord in doorframes or by heat
sources. Do not twist or bend the power cord,