Display Properties - tbs electronics Expert Modular Bedienerhandbuch

F5.5 Warning. Choose whether or not the active alarm is shown on the display ('VIS.') or an
audible alarm ('AUD') will sound. The audible alarm will stop sounding when the alarm has
been cleared, or when a key is pressed. When the audible alarm is not interrupted, the
alarm interval will slow down automatically against time.
Default: VIS.+AUD
F5.7 Alarm contact. Choose which alarm relay contact to use with this alarm. Select "OFF" to
not use any alarm contact. Select "INT." to use the battery monitor's internal alarm relay.
Select "EXT.1" to "EXT.8" to use an external alarm contact (only for use with the optional
relay accessories).
Default: INT.
The Alarms 2, 3 and 4 can be configured in respectively Functions F6.0 - F6.7, F7.0 – F7.7 and F8.0 –
F8.7. Each Function range contains the same settings options as for Alarm 1 (F5.0 – F5.7).
6.6

Display properties

These Functions can be used to personalize the normal operating mode. You can choose to skip
viewing parameters in the bottom display row that you are not interested in. The State of Charge
value shown in the upper parameter row cannot be skipped.
F9.0 Show voltage.
Default: ON
F9.1 Show current.
Default: ON
F9.2 Show power.
Default: OFF
F9.3 Show Amp-hours.
Default: OFF
F9.4 Show time remaining.
Default: ON
F9.5 Show temperature.
Default: ON
F9.7 Show bank 2 voltage. Only available when F2.0 is set to AUX.BAT.
Default: ON
Range: OFF / VIS. / VIS.+AUD
Range: OFF / INT. / EXT.1 – EXT.8
Range: OFF / ON
Range: OFF / ON
Range: OFF / ON
Range: OFF / ON
Range: OFF / ON
Range: OFF / ON
Range: OFF / ON
23