Sony CCMA-2DAR Gebrauchsanweisung Seite 18

Attachment and
Adjustment
Before attaching, remove the caps from the
camera connector and microscope connector.
Attaching the camera head
Align the lens mount thread of the camera head
with the camera connector of the unit, then turn
the camera head clockwise to secure it to the unit.
CCMA-2DAR (this unit)
Attaching to a microscope
1
Align the protrusion on the beam splitter of
the microscope with the cutout in the
microscope connector of the unit, and insert.
If the microscope is an M38 type, attach the
supplied M38 adapter attachment
beforehand.
Beam splitter
Microscope
Protrusion on beam splitter
6
GB
Attachment and Adjustment
Camera head
Cutout in microscope
connector
CCMA-2DAR (this unit)
2
Turn the lock ring attached to the beam
splitter of the microscope to secure the unit to
the microscope.
Lock ring
Attaching the controller
Insert the adapter connector of the controller into
the controller connector of the unit.
Adjusting the camera image
Adjust the orientation and position of the camera
image after attaching the camera head to the
unit.
Use a 1.5 mm hex wrench to make adjustments.
Adjusting rotation
Adjust the rotation if the orientation of the image
on a monitor does not match the image in the
eyepiece of the microscope.
1
Loosen the C mount lock screw of the unit
using a hex wrench.
The camera head attached to the unit can then
be rotated.
2
Rotate the camera head while monitoring the
monitor image until the orientation of the
images match.