SUHNER WIG 10 Originalbetriebsanleitung Seite 21

A
djustment Of sAfety guArd
Bring the safety guard into the desired working position.
For fastening the screw must be tightened down.
To release, turn screw back approx. ½ rotation.
Safe operation is guaranteed only with tightened screw.
r
emOVAl Of sAfety guArd
If necessary, release screw with Allen key. Bring bolt and
groove into alignment and remove the safety guard.
c
leAning Of lOcking mechAnism
Remove safety guard as mentioned above.
Thoroughly clean all parts. Replace defective parts.
Lubricate with a commercially available multi-purpose
grease.
Refit all parts in reverse sequence, making sure that
the drive plate and spring washers are correctly aligned
(grooves).
2.1.3 A
dditiOnAlhAndle
The additional handle must be screwed in at the left or
right, or in the gearbox head at the top.
Befor fitting, blow out the thread in the gearbox head.
2.1.4 A /
ttAching detAching the grinding tOOl
Clean backing flange, clamping nut and backing
flange surface of the grinding tool.
Place the mounting flange on the spindle so that the lon-
gitudinal groove is at the bottom.
Put on the grinding tool. The projecting centring collar on
the mounting flange must engage precisely in the hole in
the grinding tool.
21