Matrix KS 200-1 Bersetzung Der Originalbetriebsanleitung Seite 21

Use a head cover if you have long hair.
Loose clothing, jewellery, and long hair can
become entangled in moving parts.
Always wear safety goggles.
Wear a dust mask when working with materials
that produce dust.
Wear ear protection if a lot of noise is produced.
Ensure that you have a safe standing position
where you can maintain your balance at all
times.
Persons using the machines must not be
distracted.
This could cause one to lose control over the
tool.
Don't use any device that has a faulty on/off
switch. An electric tool that can no longer be
switched on or off is dangerous and must be
repaired.
Always switch the device on before coming into
contact with the material.
Remove keys and adjusting tools before
switching on the device.
Remove wrenches and setting tools before you
switch on the machine.
Check the machine for signs of damaged before
you switch it on. This will ensure that it can be
used safely.
Check that moving parts are secure, strong and
undamaged. Ensure that they are connected
correctly and other details which might affect
the handling and function of the machine.
If any parts are defective they must be repaired
correctly before the machine is used again.
Never overload the machine. If the speed drops,
unload the machine or switch it off. You will
work safer and better with the appropriate
electric tool in a specific area of application.
Only use accessories recommended by the
manufacturer.
Stop the workpiece from turning, for example
with a clamping device or a vice. Don't work on
any workpiece that is too small to clamp in
place.
If you hold the workpiece with your hand, then
you can't operate the tool safely.
Keep electric tools out of the reach of children.
Use only accessories that have been
recommended by the manufacturer. If parts and
accessories are used which are not listed in these
instructions, there is an increased risk of serious
physical injuries.
The mains voltage must correspond to the
information on the machine's type plate.
Never carry the device by the cable. Only pull
the cable from the receptacle with the plug.
Protect the cable from oil, heat, and sharp edges.
Damaged cables can cause an electric shock.
Check the device and power cable for damage
before starting work.
When plugging in the power plug, make sure
that the operating switch is not located in
position.
Only use approved extension cables when using
the device outside.
When using a cable drum, unwind it entirely in
order to prevent the cable from heating up. The
minimum wire gauge is 1.0 mm
When working outside, the receptacle must be
GB
2
.
21