Specifications - Makita TD091D Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Button
1-2. Battery cartridge
2-1. Switch trigger
3-1. Lamp
4-1. Reversing switch lever
6-1. Bit
6-2. Sleeve
7-1. Bit

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
7-2. Bit-piece
7-3. Sleeve
9-1. Limit mark
10-1. Rear cover
10-2. Screws
11-1. Spring
11-2. Arm
11-3. Recessed part
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
Overall length
Net weight
Rated voltage
noise level determined
) : 91 dB(A)
pA
) : 102 dB(A)
WA
value (tri-axial vector
2
) : 7.5 m/s
h
2
ENE033-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG905-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
ENG900-1
EC Declaration of Conformity
sum)
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Cordless Impact Driver
Model No./ Type: TD091D
are of series production and
ENG901-1
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
4
12-1. Carbon brush cap
13-1. Lead wire
13-2. Carbon brush cap
13-3. Spacer
14-1. Lead wire
14-2. Spacer
15-1. Hole
15-2. Carbon brush cap
TD091D
4 mm - 8 mm
5 mm - 12 mm
5 mm - 10 mm
0 - 2,400
0 - 3,000
134 mm
0.87 kg
D.C.10.8 V
Corporation as the
ENH101-16
responsible