Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Model assembly
Installation of the elevator pushrods
1. With the elevator servo centered, connect the pushrod to the
control horn on the elevator.
Note:Refer to the control horn and servo horn installation
instructions on page 10 for more information.
Antenna installation
1. Apply foam-safe glue on the bottom of the antenna, then
gently push the component into its wing slot.
Propeller installation
1. Install the propeller in the order as shown.
Foam-safe glue
e
HKM3.0*10
6
b
c
d
a
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
