Inhaltsverzeichnis; Introduction - FMS PA-18 Super Cub Bedienungsanleitung

Introduction

The Piper PA-18 Super Cub is a two-seat, single-engine
monoplane. It was developed from the Piper PA-11. In close to
40 years of production, over 9,000 were built. Super Cubs are
commonly found in roles such as bush flying, banner towing and
glider towing.
As a relative of the popular 1400mm J-3 Cub, the 1700mm
PA-18 Super Cub retains great flight characteristics while
offering increased power and wingspan.
Thanks to its functional flaps, high-lift airfoil, rugged landing
gear and oversized balloon tires- the 1700mm PA-18 Super Cub
has impressive short take-off and landing (STOL) performance,
allowing it to operate from just about any terrain.
Utilizing the latest FMS hardware and design, the 1700mm
PA-18 Super Cub has pre-installed ball-link type pushrods,
integrated servo connectors in the wing structure and can be
assembled very easily using no glue at all.
For pilots wanting to get the genuine bush-plane experience, the
PA-18 Super Cub can be equipped with floats.
Versatile, fun and exceptionally relaxing to fly- the 1700mm
PA-18 Super Cub is a great addition to any fleet!
Features:
• Powerful 3541- KV750 Outrunner motor with Predator 45A
ESC provides adequate thrust for any situation
• CNC metal landing gear structure for less-than-perfect landings
• 6.25-inch oversized balloon tires for all-terrain operations
• STOL capable (Takes off in less than 3m/10ft)
• Pre-installed navigation and landing lights
• Two-piece wing and horizontal stabilizer for easy transportation
Kit contents
Before assembly, please inspect the contents of the kit. The
photo below details the contents of the kit with labels. If any
parts are missing or defective, please identify the name or
part number (refer to the spare parts list near the end of the
manual) then contact your local shop or email us: support
@fmsmodel.com.
Specifications
Wingspan: 1700mm(66.9in)
Overall length: 1136mm(44.7in)
Flying weight: ~ 2100g
Motor size: 3541-KV750
Wing load: 50g/dm²(0.11oz/in²)
Wing area: 42dm²(651sq.in)
ESC: 45A
Servo: 17g Servo x 6
Recommended battery: 14.8V 2200-2600mAh 35C
• Integrated servo connectors
• Screw-together assembly
• Large battery bay
• Ball-linked pushrods for increased precision
• Tough two bladed Nylon propellers
• Functional flaps
• Optional floats and stainless-steel wing struts
Table of contents
Introduction ·····························································
Kit contents ····· ·························································3
Model assembly
·······················································4
Battery installation
·············································
Receiver diagram
·····
Preflight check ·················
Clevis installation ····················································10
Control horn and servo arm settings
Center of gravity(CG)
Before flying the model
Flying course
·················································· ·········11
Troubleshooting ······················································12
Spare parts list content
A.
B.
D. E.
H.
G.
I.
A: Fuselage E: Propeller
B: Main wing F: Screws and pushrods
C: Horizontal stabilizer G: Antenna
D: Landing gear H: Wing/ Horizontal Stabilizer spar
3
·········································
··································
····· ··························
··············································· 10
······································· ·······11
············································12
C.
F.
I:Floats and accessories
3
····· ······ 7 ··
······ 8 ··
····· ·· 8
10