Environmental Protection; Warranty - Eldom alta DA300 Bedienungsanleitung

Anti-Calc FILTER
The unit is fitted with an anti-calc filter (16) preventing limescale in the water tank (10).
The filter (16) should be cleaned every 2-4 weeks, depending on the frequency of use and hardness
of water in the area.
- Remove the tank (10) from the main house (9) and then remove the filter (12) - Fig. 3.
- Soak the filter (16) in white vinegar for at least 4 hours.
- Then rinse the filter (16) with tap water and install it in the tank (10).
- Install the tank (10) in the main house (9).
STORAGE
- Before storage, turn the device off (temperature dial on "MIN"), unplug from the power point and
check if it has cooled down.
- The water tank (10) must be empty and the device dry.
- Place and lock the iron (12) on the main house (9) - Fig. 2.
- The power cord (1) and steam cord (2) can be coiled and placed in the pocket (11).
NOTE. Do not coil the power cord (1) and the steam cord (2) too tightly, as this may lead to
damage.
- Store in a cool and dry place.
Problem
The iron (12) does not heat up.
The temperature indicator (4) is off
No steam is being produced
The soleplate (13) is dripping
water
There is a buzzing sound in the
steam cord (2)

ENVIRONMENTAL PROTECTION

- The appliance is made of materials which can be recycled.
- It should be handed over to the applicable collection point for the recycling of electrical and
electronic equipment.

WARRANTY

- This appliance is designed for domestic use only.
- It cannot be used for professional purposes or for other than the intended use.
- Improper use will nullify the guarantee
Possible cause
The device is not plugged in to a
power point.
The temperature dial has not been
rotated to the desired setting (the
temperature is too low).
The fuse has blown.
The steaming function is off.
There is no water in the tank (10).
The temperature dial has not been
rotated to the desired setting (the
temperature is too low).
Water has condensed inside the
ceramic soleplate.
The steam cord (2) is tangled.
The main house (9) is positioned
higher than the iron (12)
Solution
Plug the unit into a power point
according to the parameters
specified on the device and set
the temperature with the dial (5).
Use the dial (5) to adjust the
temperature to the requirements
for the fabric ironed.
Contact the servicing
department.
Turn on the steaming function.
Fill the tank (10).
Use the dial (5) to adjust the
temperature to the requirements
for the fabric ironed.
Wait for the iron to heat up.
Untangle the steam cord (2).
Reposition the main house (9) so
that the iron (12) is at all times
positioned higher.
•
EN 15