Filling The Water Tank; Temperature Setting; Steam Ironing - Eldom alta DA300 Bedienungsanleitung

FILLING THE WATER TANK

The device is designed to be used with normal tap water. In hard water areas it is recommended to
use distilled water.
Warning: Do not fill the tank (10) with hot water.
Warning: Never put descaling, fragrant, alcohol-based or detergent products in the device, as this
may damage the device or make it unsafe to use.
Turn the temperature dial to "MIN" and remove the plug from the mains socket.
Remove the water tank (10) from the main house (9).
Open the water inlet (15) and fill the tank with a maximum of 1.2 litres of water using a jug, ensuring
you do not exceed the MAX fill line.
Close the water inlet (15) and slide the tank (10) back into the main house (9).
CAUTION. Exert caution when filling the tank (10) during ironing.
NOTE: Before you remove the tank (10) from the main house (9) and open it make sure there is no
steam inside. To do so, press the shot of steam button (7) until no more steam escapes.
Then follow the instructions above.

TEMPERATURE SETTING

Always refer to the garment manufacturer's recommendations for the correct temperature setting.
If the type of the fabric is unknown, start with the lowest temperature and increase it gradually until
a satisfactory result is reached.
To increase the temperature, turn the temperature dial (5) clockwise until the desired temperature is
selected. To reduce the temperature, turn the temperature dial (5) counter clockwise.
Once the indicator light (4) has stopped flashing, the unit is ready for use.
The temperature dial will maintain the selected temperature, which will be indicated by the indicator
light turning on and off (4).

STEAM IRONING

Caution: Avoid touching the steam cord (2) when the device is in use, as it gets hot.
Caution: The steam ejecting from the steam holes (14) is hot. Contact can result in burns.
Steam ironing is only possible when the temperature setting is high; the temperature dial
must be on "ooo".
- Place the unit on a stable, hard, horizontal and heat-resistant surface.
- Fill the tank (10) according to the instructions in the "FILLING THE WATER TANK" section.
- Make sure that the iron (12) is not locked - Fig.2
- Plug the unit into a power point according to the parameters specified on the device.
- Set the required temperature as recommended in the "TEMPERATURE SETTING" section.
- Once the indicator light (4) has stopped flashing, the unit is ready for use.
- Steam ironing:
- steam shot - you can use the shot of steam button (7) to instantly produce a powerful shot of
steam. The steam will be ejected as long as the button is pressed. Releasing the button will stop
the steam from escaping.
- continuous steam - to enable the continuous steam function, set (6) on "
turn the continuous steam button (6) to "
- Once you have finished ironing, turn (6) to "
the unit from the power point.
Caution: When not in use, the iron (12) should rest on the main house (9).
Warning: Avoid a long period of ironing on one specific area, as this may cause damage to the fabric.
".
" and the temperature dial (5) to "MIN" and unplug
", to disable steaming,
•
EN 13