Reset To Factory Default Settings - Axis Communications A1001 Installationsanleitung

To prevent network eavesdropping, the root password can be set via an encrypted HTTPS connection,
which requires an HTTPS certificate. HTTPS (Hypertext Transfer Protocol over SSL) is a protocol
used to encrypt traffic between web browsers and servers. The HTTPS certificate ensures encrypted
exchange of information.
The default administrator user name root is permanent and cannot be deleted. If the password for
root is lost, the product must be reset to the factory default settings. For information about how to
reset the product to factory default, see the product's User Manual.
To set the password via a standard HTTP connection, enter it directly in the dialog.
To set the password via an encrypted HTTPS connection, follow these steps:
1. Click Use HTTPS.
A temporary certificate (valid for one year) is created, enabling encryption of all traffic to
and from the product, and the password can now be set securely.
2. Enter a password and then re-enter it to confirm the spelling.
3. Click OK. The password has now been configured.

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available from the support pages
on www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See Hardware Overview on
page 13.
3. Keep the control button pressed for about 25 seconds until the status LED indicator
turns amber for the second time.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90
5. Using the installation and management software tools, assign an IP address, set the
password, and access the product.
It is also possible to reset parameters to factory default via the web interface. Go to Setup >
Additional Controller Configuration > Setup > System Options > Maintenance.
AXIS A1001 Network Door Controller
39