Powering Off The Projector - Eiki EIP-WSS3100 Schnellstartanleitung

Powering On the Projector
1. Securely connect the power cord and signal cable. When connected, the Power
LED will turn red.
2. Turn on the lamp by pressing
control. The Power LED will turn blue.
3. Turn on your source that you want to display on the screen (computer, note-
book, video player, etc). The projector will detect the source automatically and
will display on the screen.
4. If you connected multiple sources at the same time, press the "Source" button
on the remote control to switch between inputs.

Powering Off the Projector

1. Press the " " button on the control panel or on the remote control
the projector. The following message will be displayed on the screen.
Press the " " button again to confirm.
Power Off?
Press power key again.
2. The Power LED will turn red and blink rapidly after the projector is turned off.
And the fans will continue to operate for about 90 seconds to ensure that the
system cools properly.
3. Once the system has finished cooling, the Power LED will stop blinking and turn
solid red to indicate standby mode.
4. It is now safe to unplug the power cord.
" " button on the control panel or on the remote
Adjusting
POWER TEMP LAMP
RESYNC SOURCE
MENU
or
to turn off