Hatco FSHACH Serie Installations- Und Bedienungshandbuch Seite 8

IMPORTANT SAFETY INFORMATION
WARNINGS
This appliance is not jet-proof construction. Do not use
jet-clean-spray to clean this appliance.
To avoid electrical shock or personal injury, do not
steam clean or use excessive water on the unit.
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
Unit is not waterproof. To avoid electrical shock or
personal injury, DO NOT submerge in water. Do not
operate if it has been submerged in water.
Do not lay unit on the side with the control panel or
damage to the unit could occur.
To avoid any injury, turn the power OFF to the unit and
allow to cool before draining.
To prevent any injury or damage to the unit do not pull
unit by power cord.
To prevent any injury, discontinue use if power cord is
frayed or worn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement Parts
may subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco
Parts when service is required.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the Hatco
Service Department at 414-671-6350; International fax
414-671-3976.
For proper plumbing installation conforming to local
plumbing codes, consult a licensed plumbing
contractor.
Form No. FSHACCEM-0807
Unit is not weatherproof. For safe and proper operation
the unit must be located indoors where the ambient air
temperature is a minimum of 21°C (70°F) and
a maximum of 29°C (85°F).
To assure proper operation and to avoid damage to the
unit, the incoming water supply pressure must be at
least 241 kPa (35 psi) and not to exceed 552 kPa
(80 psi).
To assure proper operation and to avoid damage to the
unit, the incoming water supply temperature must not
exceed 60°C (140°F).
Use only non-abrasive cleaners. Abrasive cleaners
could scratch the finish of your unit marring its
appearance and making it susceptible to soil
accumulation.
To assure proper operation and extend the life of
humidified models utilizing the auto-fill system, the
water filter cartridge must be installed in the water
supply line.
Do not use de-ionized water. De-ionized water will
greatly shorten the life of the water heating elements
and plumbing components.
Water Quality Requirements - Incoming water in excess
of .75 grains of hardness per liter (3.0 grains of
hardness per gallon (GPG)) must be treated and
softened before being used. Water containing over
.75 GPL (3.0 GPG) will decrease the efficiency and
reduce the operating life of the unit.
Do not over tighten plumbing connections. Over
tightening may cause leaks.
6
CAUTIONS
NOTICES