Removing Lime & Mineral Deposits; Accessories - Hatco FSHACH Serie Installations- Und Bedienungshandbuch

REMOVING LIME & MINERAL DEPOSITS
CAUTION
Water Quality Requirements - Incoming water in excess of
.75 grains of hardness per liter (3.0 grains of hardness per
gallon (GPG)) must be treated and softened before being
used. Water containing over .75 GPL (3.0 GPG) will
decrease the efficiency and reduce the operating life of the
unit.
NOTE: Product failure caused by liming or sediment buildup is
not covered under warranty.
NOTE: If the water used has an excessive amount
of lime or mineral content, follow the instructions listed below
for periodic cleaning and deliming of the water reservoir.
1. Turn the power switch off and unplug the unit from its
power source.
2. After the unit has cooled down, drain all remaining water
out of the unit. See DRAINING THE RESERVOIR.
3. Fill the unit with a mixture of water and delimer.
NOTE: The delimer used should be a safe, non-toxic, non-
corrosive solution. Follow the delimer's instruction for proper
mixture of water and delimer solution.
4. Allow the unit to stand with the mixture in the reservoir for
the recommended period of time. (The time required will
vary depending on the solution used and amount of
deposits in the reservoir.)
5. After the deliming period, drain the solution from the tank.
6. Continue to fill and drain the unit with water only, until the
discharge is clear and all deliming solution has been
removed and rinsed.
7. Plug the cabinet power cord into its power source and fill
the unit as usual for daily operation.
NOTE: How often this procedure must be performed depends
on the lime and mineral content of the water used for daily
operation.
BACK-TO-BACK MOUNTING KIT
Special brackets are available for mounting two non-pass-
through units back-to-back on a single base. Mounting
hardware is supplied with mounting kit. (See 14 )
NOTE: Installing the kit adds 25 mm (1") to overall height of
units.
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service
Department at 414-671-6350;
414-671-3976.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco Parts
when service is required.
Genuine Hatco Replacement
to operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts do
not have the characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use Hatco
Replacement Parts when repairing Hatco equipment.
Failure to use Hatco Replacement Parts may subject
operators of the equipment to hazardous electrical
voltage, resulting in electrical shock or burn.
PANS
Aluminum half-size bun pans 457 x 330 mm (18" x 13") are
available for the stationary style racks.
13
MAINTENANCE
WARNING
International
WARNING
WARNING
Parts are specified

ACCESSORIES

Form No. FSHACCEM-0807
fax