Maintenance; General; Cleaning; Filter Cartridge Replacement - Hatco FSHACH Serie Installations- Und Bedienungshandbuch

MAINTENANCE

GENERAL

The Hatco Flav-R-Savor ® Air Curtain Cabinets are designed
for maximum durability and performance, with minimum
maintenance.
WARNING
To avoid any injury, turn the power switch OFF, unplug the
unit from the power source and allow to cool before
performing any maintenance.

CLEANING

WARNING
To avoid electrical shock or personal injury, do not steam
clean or use excessive water on the unit.
WARNING
Unit is not waterproof. To avoid electrical shock or
personal injury, DO NOT submerge in water. Do not
operate if it has been submerged in water.
To preserve the bright finish of the Flav-R-Savor cabinet, it is
recommended that the exterior and interior surfaces be wiped
daily with a damp cloth. Food pans should be removed and
washed. Air distribution duct is removable for cleaning.
Stubborn stains may be removed with a good stainless steel
cleaner or a non-abrasive cleaner. Hard to reach areas should
be cleaned with a small brush and mild soap.
WARNING
This appliance is not jet-proof construction. Do not use
jet-clean-spray to clean this appliance.
NOTICE
Use only non-abrasive cleaners. Abrasive cleaners could
scratch the finish of your unit marring its appearance and
making it susceptible to soil accumulation.
FILTER CARTRIDGE
(HATCO PART NO. 03.05.079.00) (SEE 12 )
Replace cartridge filter when any of the following occur:
• Noticeable drop in water flow.
• Unpleasant tastes and/or odors return.
• Cartridge capacity is reached.
• Pressure gauge reads 10 psi during flow.
• Every six months.
Follow these instructions when replacement is necessary:
1. Turn off water supply.
2. Remove old cartridge.
NOTE: Install filter cartridge flow with arrow towards the
equipment.
3. Insert water supply tubing into filter cartridge. Secure
tubing with fittings.
Form No. FSHACCEM-0807
REPLACEMENT
12
4. Attach minimum tubing length from filter cartridge to
equipment. Secure tubing with fittings.
5. Connect filter cartridge assembly to equipment water
supply inlet.
6. Turn water supply on. Check for leaks before leaving
installation.
NOTE: Flush new filter
five minutes before use.

DRAINING THE RESERVOIR

WARNING
To avoid any injury, turn the power OFF to the unit and
allow to cool before draining.
It is recommended that the Flav-R-Savor ® water reservoir be
drained prior to moving the cabinet and after removing lime or
mineral deposits from the water reservoir.
NOTE: The drain hose assembly is supplied with the unit.
NOTE: Position a container to hold the water while draining.
NOTE: To ease installation, moisten the inside of the drain
hose end with water before installing.
1. Insert the drain hose fitting into the water outlet, located on
the ceiling of the cabinet. Once the fitting is installed, water
will begin to drain from the hose. (See 13 )
2. Once the unit has finished draining, the drain tube
assembly can be removed by pressing the release tab and
gently pulling the fitting out.
cartridge with water for