Wall Installation - urmet 1092/679 Schnellanleitung

5.1.1

WALL INSTALLATION

Identify the camera installation point and proceed as follows:
Include a connection box for making connections and fitting the power unit, if required.
Drill holes according to the type of wall (cement, wood, etc.) and the fastening devices used.
If the type of installation includes laying of cables in sight, unscrew the plug on the lower part of the bracket with
a slot type screwdriver and insert all the functioning cable of the dome inside the bracket, providing a suitable
protection conduit for the cables.
Insert the connection cables (power-video-data) inside of the bracket until they exit from the opposite side.
Fasten the bracket to the dome screwing the 3 screws at the end of the bracket
Fasten the bracket to the wall.
Open the metal cover inside the plastic housing to find the configuration switch.
Follow the configuration settings for Easy Dome correct functioning (see paragraph – Dome settings).
Close the metal cover
Connect camera video output cable to the display device.
Connect Red/Black power cable to the included power supply.
Connect RS485 Yellow/Orange cable to the control keyboard.
Connect Yellow/Green cable to ground outlet.
Connect the power cable to the supplied PSU
DS1092-233 15