Automatic Switch-Off; The Heat Setting; Automatic Heat Up - Electrolux EHF3320FOK Benutzerinformation

4.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• All cooking zones are deactivated.
• You do not set the heat setting after
you activate the hob.
• You spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• You do not deactivate a cooking zone
or change the heat setting. After some
time comes on and the hob
deactivates. See below.
The relation between heat setting and
times of the function:
• , 1 - 2— 6 hours
• 3 - 4 — 5 hours
• 5 — 4 hours
• 6 - 9 — 1.5 hours

4.3 The heat setting

Touch to increase the heat setting.
Touch to decrease the heat setting.
Touch and at the same time to
deactivate the cooking zone.
4.4 Activating and deactivating
the outer rings
You can adjust the surface you cook to
the dimension of the cookware.
Use sensor field:
To activate the outer ring: touch the
sensor field. The indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.

4.5 Automatic Heat Up

If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch until the correct heat
setting comes on. After 3 seconds
comes on.
To deactivate the function: touch
4.6 Timer
Count Down Timer
You can use this function to set how long
the cooking zone operates for only this
one time.
First set the cooking zone then set the
function. You can set the heat setting
before or after you set the function.
To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on.
To activate the function or change the
time: touch
or
the time (00 - 99 minutes). When the
indicator of the cooking zone starts to
flash slowly the time counts down.
To see the remaining time: set the
cooking zone with
cooking zone starts to flash quickly. The
display shows the remaining time.
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
When the time comes to an
end, the sound operates and
00 flashes. The cooking zone
deactivates.
To stop the sound: touch
Minute Minder
You can use this function as a Minute
Minder when the hob is activated and the
cooking zones do not operate (the heat
setting display shows
To activate the function: touch
Touch or of the timer to set the
ENGLISH 23
.
of the timer to set
. The indicator of the
and touch . The
.
).
.