Herunterladen Inhalt Inhalt Diese Seite drucken

Use; Using The Product Disconnected From A Power Supply; Troubleshooting - Parkside PATC 2 A1 Bedienungs- Und Sicherheitshinweise

Akku-arbeitsleuchte
Vorschau ausblenden Andere Handbücher für PATC 2 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Note: If the product has not been charged for an extended period
of time (approx. 2 months), you could find that the integral recharge-
able battery has entered a dormant state. Charge and discharge the
product a number of times in succession to reactivate the integral
rechargeable battery.
Connect the USB cable
adapter
8
Connect the micro-USB connector on the USB cable
micro-USB input socket
Plug the mains adapter
into the cigarette lighter socket in your vehicle.
9
Note: During charging from a cigarette lighter socket, ensure
that the car adapter is always completely inserted into the ciga-
rette lighter socket of the vehicle. Failure to observe this advice
may result in risk of fire from overheating.
Note: The product has an overcharging protection system.
Nevertheless, you should disconnect the product from the mains
once the charging process is complete.
Note: The charging indicator
charging process. When the charging process is complete, the
charging indicator
indicator
of the mains socket or the car adapter
lighter socket. Disconnect the mains adapter
adapter
9
from discharging themselves.

Use

CAUTION – RISK OF ACCIDENT! If at all possible, do not use
the product in a moving vehicle. If the product is used in a vehicle, it
must not be allowed to endanger the safety of the driver or passengers.
Always store and secure the product in such a way that there is no
risk of injury from or damage to the product, even during full braking.
Note: You can secure the product by using the hook
netic base
4
the product up to 180° on the magnetic base
can be rotated to a desired angle.
CAUTION! Please note the position of your hands whilst turning the
magnetic holder to prevent pinching your fingers (see Fig. C).
Using the product disconnected from
a power supply
Fully charge the product, as described in the section on
"Charging the product".
The product can be operated in 3 different modes, select these by
repeatedly pressing the ON / OFF switch
press once:
press twice:
press three times: Switches off the product.

Troubleshooting

Fault
No functions - Mains adapter
16 GB/IE
10
or the car adapter
6
8
illuminates green. When the charging
5
illuminates green, pull the mains adapter
5
from the product to prevent the rechargeable battery
on a flat, ferromagnetic surface. Use the joint
The strip light
The strip light
Possible causes and cures
inserted.
- Check the mainpower socket can be functioned
properly.
- Check the house's fuse.
with the USB connector of the mains
.
9
on the product.
into a socket, or plug the car adapter
illuminates red during the
5
out of the cigarette
9
4
.
3
lights up at full power.
2
lights up at low power.
2
or car adapter
8
to the
10
out
8
or the car
8
or the mag-
1
to tilt
7
. The strip light
2
is not fully
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis