Makita BTD133 Bedienungsanleitung Seite 6

Changing the hammering force
Fig.6
Hammering force grade
displayed on panel
Hard
S H
Medium
S H
Soft
S H
011189
The hammering force can be changed in three steps:
hard, medium and soft.
This allows a tightening suitable to the work.
Every time the hammering force button
number of blows changes in three steps.
For approximately one minute after releasing the switch
trigger, the hammering force can be changed.
NOTE:
When all lamps on the switch panel go out, the tool
•
is turned off to save the battery power. The hammer
force grade can be checked by pulling the switch
trigger to the extent that the tool does not operate.
During the operation of switch trigger, the hammer
•
force grade cannot be changed.
Empty signal for remaining
battery capacity
Fig.7
Pulling the trigger switch when the remaining battery
capacity become very low makes LED indicator flicker.
If the tool is used continuously with the LED indicator
flickering up and the battery power is almost used up, the
LED indicator will light up and the tool itself will stop
Please refer to the following table for the LED indicator
status and the remaining battery capacity.
Maximum blows
BTD133 BTD145
Tightening when force
3,400
3,200
and speed are desired.
-1
-1
(min )
(min )
2,800
2,600
Tightening when a good
-1
-1
(min )
(min )
finishing is needed.
Tightening when excessive
tightening need to be avoided
1,300
1,100
because of potentially clogged
-1
-1
(min )
(min )
female screw and broken or
damaged screw head.
is pressed, the
Application
LED indicator status
OFF
Flickering
Lighting on
011188
NOTE:
When all lamps on the switch panel go out, the tool
•
is turned off to save the battery power. The
remaining battery capacity can be checked by
pulling the switch trigger to the extent that the tool
does not operate.
All of the lamps on the switch panel go out
•
approximately one minute after releasing the switch
trigger.
When the tool temperature is high, the LED
•
indicator may flicker or light up.
If the LED indicator lights up and the tool stops
•
even with a recharged battery cartridge, cool down
the tool temperature fully. When the status is still
unchanged, stop using and have the tool repaired
by a Makita local service center.
6
Work
Tightening in underwork
material/ Tightening long
screws/ Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.
Remaining battery capacity
Enough
20%
Very low and the tool will stops