Specifications - Makita BTD133 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Switch trigger
3-1. Lamp
4-1. Light button
5-1. Reversing switch lever

SPECIFICATIONS

Capacities
-1
No load speed (min )
Impacts per minute
Overall length
Net weight (with battery cartridge)
Rated voltage
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model BTD133
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model BTD145
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Explanation of general view
6-1. Changed in three steps
6-2. Hard
6-3. Medium
6-4. Soft
6-5. Hammering force button
7-1. LED indicator
9-1. Bit
Model
Machine screw
Standard bolt
High tensile bolt
Hammer mode (Hard)
Hammer mode (Medium)
Hammer mode (Soft)
Hammer mode (Hard)
Hammer mode (Medium)
Hammer mode (Soft)
) : 92 dB(A)
pA
) : 103 dB(A)
WA
) : 93 dB(A)
pA
) : 104 dB(A)
WA
BTD133
4 mm - 8 mm
5 mm - 14 mm
5 mm - 12 mm
0 - 2,400
0 - 1,800
0 - 1,100
0 - 3,200
0 - 2,600
0 - 1,100
With one-touch bit holder 139 mm
Without one-touch bit holder 140 mm
1.4 kg
D.C.14.4 V
ENE033-1
Model BTD133
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
ENG905-1
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model BTD145
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 2.0 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENG900-1
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
9-2. Sleeve
10-1. Bit
10-2. Sleeve
11-1. Groove
11-2. Hook
11-3. Screw
BTD145
4 mm - 8 mm
5 mm - 14 mm
5 mm - 12 mm
0 - 2,600
0 - 2,000
0 - 1,300
0 - 3,400
0 - 2,800
0 - 1,300
With one-touch bit holder 139 mm
Without one-touch bit holder 140 mm
1.3 kg
D.C18 V
2
) : 11.0 m/s
h
2
2
) : 12.0 m/s
h
2
ENG901-1