Installation; Before The Installation; Built-In Hobs; Connection Cable - Electrolux EIV65343 Benutzerinformation

22 www.electrolux.com
Problem
and a number come on. There is an error in the
You can hear a constant
beep noise.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

9. INSTALLATION

WARNING!
Refer to Safety chapters.

9.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................

9.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.

9.3 Connection cable

• The hob is supplied with the
connection cable.
• Replace the damaged mains cable
only with the spare parts cable. Speak
Possible cause
hob.
The electrical connection is
incorrect.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
to your local Authorised Service
Center.
Two-phase connection
1. Remove the cable end sleeve from
2. Remove an insulation of the brown
3. Apply a new wire end sleeve of 1.5
Remedy
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.
WARNING!
All electrical connections
must be made by a qualified
electrician.
CAUTION!
Do not drill or solder the wire
ends. This is strictly
forbidden!
CAUTION!
Do not connect the cable
without cable end sleeve.
black and brown wires.
and black cable ends.
mm² on each cable end. (special tool
required).
comes on