Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Connect the plug into an electrical socket and switch on at the wall.
•
You can control your stand fan either with the Remote Controller or with Control Buttons on the con-
trol panel.
•
Press the "ON/SPEED" button. At first start-up the fan will operate at low speed.
•
Press the same button to choose between Low, Medium and High speed.
•
Press "SWING" button to switch on the oscillation mode.
•
Press „Mode" to select one of the 3 wind mode namely normal wind mode, natural wind mode, slee-
ping wind mode.
•
Press „TIMER" to set the timing up to 7.5 hours.
•
•
Cleaning
•
Switch off and unplug from the power supply before assembling or disassembling and cleaning.
•
Keep the air vents at the rear of the main body free from dust or fluff– use a vacuum cleaner to re-
move these when necessary. Do not probe any opening to remove fluff.
•
Fan component parts should be cleaned using mild soap and a damp cloth or sponge. Do not allow
any water or other liquid to enter the motor housing.
•
Thoroughly remove soap film with clean water.
Power rating: 230V AC ~ 50Hz
Dimensions: Height variable; fan Ø 16"
According to the European waste regulation 2002/96/EG this symbol on the product or
on its packaging indicates that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. For more
detailled information about recycling of this product, please contact your local council or
your household waste disposial service.
Producer: CHAL-TEC Vertriebs- + Handels GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2004/108/EC
(EMC)
2011/65/EU
(RoHS)
2006/95/EC
(LVD)
7
Operation
The sensor of the remote control must be pointed at the fan receiver to ope-
rate properly.
The distance between the remote and receiver should be no more than 6
metres and 30 degrees radius left to right of the fan.
Technical Data
Environment Concerns
Declaration of Conformity
Werbung
