Connecting Speakers; How To Connect - Yamaha AX-596 Bedienungsanleitung

Connecting speakers

Connect the SPEAKERS terminals to your speakers with
the wire with the proper gauge (keep it as short as
possible). If the connections are faulty, no sound will be
heard from the speakers. Make sure that the + and –
polarity markings of the speaker wires are observed and set
correctly. If these wires are reversed, the sound will be
unnatural and lack bass.

How to Connect:

SPEAKERS A terminals
Red: positive (+)
Black: negative (–)
1
Loosen the knob.
2
Insert the bare wire. [Remove approx.
10 mm (3/8") insulation from the speaker wires.]
3
Tighten the knob and secure the wire.
8
E-
2
1
3
● One or two speaker systems can be connected to this
unit. If you use only one speaker system, connect it to
either the SPEAKERS A or B terminals.
● Use speakers with the specified impedance shown on the
rear of this unit.
Caution
Do not let the bare speaker wires touch each other or
any metal part of this unit. This could damage this unit
or the speakers, or both.
SPEAKERS B terminals
Red: positive (+)
Black: negative (–)
2
1
3
<
U.S.A., Canada, Australia, China and General
>
models only
Banana Plug connections are also possible.
2
1
Tighten the terminal knob.
2
Simply insert the Banana Plug connector into the
terminal.
1
Loosen the knob.
2
Insert the bare wire.
[Remove approx.
10 mm (3/8")
insulation from the
speaker wires.]
3
Tighten the knob
and secure the wire.
1