Installation Instructions; Step 1 - Unpack Air Conditioner; Step 3 - Attach Exhaust Pipe Assembly To The Window Panel - Haier AM09AA1TAA Installations- Und Bedienungsanleitung

REQUIRED GROUNDING METHOD
This air conditioner must be grounded. The air conditioner is
equipped with a power supply cord that has a grounding
plug. The power supply cord must be plugged into a mating,
grounded outlet, and grounded in accordance with all local
codes and ordinances.

INSTALLATION INSTRUCTIONS

STEP 1 - UNPACK AIR
CONDITIONER
WARNING
Excessive Weight Hazard
Use two or more people to move and install air
conditioner.
Failure to do so can result in back or other injury.
•
Remove packaging materials. Save the carton and the
foam packaging for storing the air conditioner when not
in use.
NOTE: There are NO packing materials inside the
air conditioner to remove―Do Not open the cabinet.
•
Properly dispose of/recycle all packing material.
•
Handle the air conditioner gently.
•
Keep the air conditioner upright and level. Do not set the
air conditioner on its side, front, back or upside down.
STEP 2 - INSTALL MAIN WINDOW
PANEL AND EXTENSION PANELS
NOTE: Depending on the size of your window opening,
use the main panel and one or both of the extension
panels.
1. Open the window and place the main window panel into
the window.
NOTE: The window assembly is designed to
accommodate either a vertical slide or horizontal
slide window.
Vertical Slide Window
a
A Main Window Panel
Horizontal Slide Window
2. Adjust the extension panel to t the width or height
of the window as shown.
NOTE: Some window installations may require the
extension panels to be trimmed.
3. Use one flat screw to secure the main panel to
the extension panel.
STEP 3 - ATTACH EXHAUST PIPE
ASSEMBLY TO THE WINDOW PANEL
1.
Grasp both ends of the exhaust hose and gently pull to
expand the hose.
NOTE: Do not attach additional hoses to extend the
length. This would decrease cooling efficiency and
may damage the air conditioner.
2.
Insert the air exhaust hose into the window sealing plate,
fix it with screws
5
230V
16 Amp
A Main Window Panel
a