Device Usage - Klarstein Aquavita Chalet Bedienungsanleitung

DEVICE USAGE

1. To fill the stove, remove it from the base station to fill the kettle, open the lid or fill it
through the spout. Fill the kettle with a minimum of 0.5 To maximum of 1.7 Litres of
water. Too little water will cause the kettle to switch off before the water boils.
Note: make sure that the lid is securely in place before placing the kettle on the base
station.
2. Place the kettle on the base station.
3. Connect the plug to the power outlet. Operate the switch. The power indicator
will light up. The water will now boil. If the water boils, the kettle will switch off
automatically. You can switch off the appliance at any time during boiling by
pressing the switch.
Note: make sure that the switch is accessible and is not blocked. If the switch is
blocked or the lid is open, the appliance will not shut off.
4. Remove the cooker from the base station and pour out the water
Note: be careful when pouring the water. Contact with boiling water can cause
burns.
5. The cooker will not boil until the switch is pressed again. Allow the unit to cool for
15 to 20 seconds before starting cooking again. The cooker can be left on the base
station when not in use.
Note: make sure the power is off when the cooker is not in use.
6. Dry run protection: if the cooker is accidentally left without water, the dry run
protection will automatically turn off the unit. If this occurs, allow the stove to cool
down before using it.
EN
13