Replacing The Fan; Removing The Cover; Fitting The Cover - Kaco blueplanet 87.0 TL3 Betriebsanleitung

7.3

Replacing the fan

Removing the cover

↻ A check has been performed to ensure there is no AC/DC voltage present.
1 Remove the fastening screws on the cover from both sides [ _T20]
2 Lift up the cover from both sides and press it out of the mounting clips.
3 Set the cover to one side.
» Proceed with the cleaning or removal of the fans.
Removing the fans
↻ A check has been performed to ensure there is no AC/DC voltage present.
↻ Cover hood for fans removed.
1 Wait until the 3 fans have stopped rotating.
2 Rotate the defective fan through approx. 10° in the clockwise direction and re-
move it carefully using the collar.
3 Release the interlock and remove the connector plug from the inside of the
housing.
4 Remove the fan.
5 If necessary, clean the heat sink from above.
» Install the replacement fan.

Fitting the cover

↻ The fan has been correctly installed and all impurities in the area of the cover
have been removed.
1 Lift up the cover from both sides, place it on the mounting clips and carefully
press it in.
2 Insert the fastening screws into the cover on both sides and tighten them [
_T20 / 2.2 Nm].
» You may now start up the device Commissioning.
Page 24 KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
4
3
2
Fig. 22: Removing the cover
1 Cover
2 Fastening screw
3 Mounting clips
4 Fans
1
Fig. 23: Removing the fans
1 Fans
2 Connector
2
Fig. 24: Fitting the cover
2 Fastening screw
KACO blueplanet 137 TL3 KACO blueplanaet 150 TL3
1
2