Surveying The Connection Area; Making The Electrical Connection - Kaco blueplanet 87.0 TL3 Betriebsanleitung

6.3

Surveying the connection area

The connection point for the AC supply is situated inside the housing. The DC input source is also connected inside the
housing.
6
5
4
Fig. 12: Connection area on DC side (left) / AC side (right)
Legend
1 AC connection point
2 AC overvoltage protection base
3 AC earthing bolt
6.4

Making the electrical connection

NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic condi-
tions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation;
local temperature
6.4.1 Requirement for supply lines and fuse
AC-side
Max. conductor cross-section
Min. cable cross-section
Cable diameter for cable fitting
Length of insulation to be stripped off
Cable lug Ø connection bolt
Tightening torque
Connection type
Cable lug dimension w - maximum width
Ground conductor connection
Ground conductor connection tightening torque
Fuse protection for installation provided by customer
Fitting for AC connection
Torque for cable fitting
DC-side
Max. conductor cross-section
Min. cable cross-section
Cable diameter for cable fitting
Cable lug dimension w width max
Length of insulation to be stripped off
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
KACO blueplanet 137 TL3 KACO blueplanaet 150 TL3
1
2
3
4 DC connection point
5 DC overvoltage protection
6 PID connection point
240mm² (AL or CU)
in accordance with installation standards
16 - 28 mm
Depending on the ring cable lug
Bore for M10 screw
30 Nm
Cable lug
42 mm
M10
10 Nm
max. 250A
M40
7.5 Nm
240mm² (AL or CU)
in accordance with installation standards
16 - 28 mm
42 mm
Depending on the ring cable lug
Page 17