Altering An Option Or A Running Programme - AEG LP 2252 F Benutzerinformation

12
Daily use
Select the STAIN option (Button 4)
Select this option to treat heavily soiled or stained laundry with stain remover (extended
main wash with time optimized stain action phase). The relevant light will light up.
This option is not available with a temperature lower than 40°C.
If you wish to perform a programme with the stain option, pour stain remover into com-
partment
Select the TIME SAVING option (button 5)
This option allows you to modify the washing time, automatically proposed by the appli-
ance.
By pressing this button you can select the following options:
DAILY: by pressing button 5 once, the corresponding symbol appears on the display and the
washing duration will be reduced to wash daily soiled laundry. Reduced washing time is
presented on the display.
SUPER QUICK: by pressing button 5 twice, the corresponding symbol remains lit on the dis-
play and the washing duration will be reduced to wash lightly soiled laundry or items that
have been used or worn for a short time. Reduced washing time is presented on the display.
Select an additional rinse (EXTRA RINSE)
This appliance is designed for saving water. However, for people with a very delicate skin
(allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of
water.
Press simultaneously buttons 2 and 3 for some seconds: the pilot light 8.3 comes on. This
function stays permanently on. To remove it press the same buttons again until the pilot
light 8.3 goes off.
Select the START/PAUSE (Button 7)
To start the selected programme, press the button 7, the corresponding red pilot light stops
blinking.
The pilot light 8.1 is on to indicate that the appliance starts operating.
The pilot light 8.2 is on to indicate the door is locked.
To interrupt a programme which is running, press the button 7: the corresponding red pilot
light starts blinking.
To restart the programme from the point at which it was interrupted, press the button 7
again.
If an incorrect option is selected, the yellow pilot light of the button 7 blinks for 3 times the
message Err is displayed for about 2 seconds.

Altering an option or a running programme

It is possible to change some options before the programme carries them out. Before you
make any change, you must pause the washing machine by pressing the button 7.
Changing a running programme is possible only by resetting it. Turn the programme selec-
tor dial to
pressing the 7 button again. The washing water in the tub will not emptied out.
.
and then to the new programme position. Start the new programme by