Programme Option Buttons - AEG LP 2252 F Benutzerinformation

Turn the programme dial (1) to set the required programme
You can choose the right programme for any type of laundry following the descriptions on
the washing programme tables (see «Washing Programmes» ).
Turn the programme dial to the required programme. The programme dial determines the
type of washing cycle (e.g. water level, drum movement, number of rinses) and the washing
temperature according to the type of laundry.
The light of button 7 starts blinking and the display shows the duration of the selected pro-
gramme.
The programme dial can be turned either clockwise or anticlockwise.
Position
At the end of the programme the selector dial must be turned to position
switch the machine off.
If you turn the programme selector dial to another programme when the machine is work-
ing, the yellow pilot light of button 7 will blink 3 times and the message Err is displayed on
the display to indicate a wrong selection. The machine will not perform the new selected
programme.

Programme option buttons

Depending on the programme, different functions can be combined. These must be selected
after choosing the desired programme and before you press the button 7.
When these buttons are pressed, the corresponding pilot lights come on. When they are
pressed again, the pilot lights go out.
If you set an incorrect option, the in yellow pilot light of the button 7 blinks for 3 times and
the Err message appears on the display for some seconds.
For the compatibility among the washing programmes and the options see chapter «Wash-
ing Programmes».
Select the SPIN speed or the RINSE HOLD option (Button 2)
When the required programme has been selected, your appliance automatically proposes
the maximum spin speed provided for that programme.
Press this button repeatedly to change the spin speed, if you want your laundry to be spun
at a speed different from the one proposed by the washing machine.
The relevant light will light up.
RINSE HOLD: by selecting this option the water of the last rinse is not emptied out to pre-
vent the fabrics from creasing. When the programme has finished the display shows a
blinking , the pilot light 8.2 goes on, the pilot light of button 7 is off and the door is
blocked to indicate that the water must be emptied out.
To empty the water out please read chapter «At the end of the programme».
Select the PREWASH option (Button 3)
Select this option if you wish your laundry to be prewashed at 30°C before the main wash.
The Prewash ends with a short spin in programmes for cotton and synthetic fabrics, where-
as in the programmes for delicate fabrics the water is only drained.
The relevant light will light up.
= Reset programme / Switching OFF of the machine.
11
Daily use
, to