Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INsTALLATIoN
Installation
3.3 Standard delivery
The following are delivered with the appliance:
- 2 fixings for top-hat rail mounting
4. Installation
Note
The connected controllers and actuators must match
the connected power supply.
Note
The appliance is suitable for mounting on a top-hat
rail or on the wall.
f To mount the appliance on a wall or directly in the casing
f
of the heat interface unit, carry out the following steps:
f Release the appliance cover at the two locking points. Re-
f
move the appliance cover.
f Align the appliance horizontally.
f
f Mark and drill the fixing holes.
f
f secure the appliance with suitable rawl plugs and screws
f
(Ø 4 mm). Tighten the screws until finger-tight.
E10 RKL, Z10 RKL
f Route the power cable through the strain relief into the
f
appliance enclosure.
f Wire the appliance.
f
f Fit the appliance cover.
f
f switch the power supply oN.
f
4.1
Inserting the fuse
f To insert the fuse, proceed as shown:
f
5. Removal
f Disconnect the entire system from the power supply.
f
f Disconnect the wiring to all externally connected
f
components.
f Remove the appliance.
f
T4AH
| 15
Werbung
Kapitel
Inhaltsverzeichnis
