Functional Description - Makita M4000 Bedienungsanleitung

General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.
BLOWER SAFETY WARNINGS
1. Always use protective goggles, a cap and
mask when using the blower.
2. Never point the nozzle at anyone in the
vicinity when using the blower.
3. Warning - Electric shock could occur if used
on wet surfaces. Do not expose to rain. Store
indoors.
4. Never block suction inlet and/or blower outlet.
Increased motor
dangerous fan breakage.
5. The blower is not intended for use by young
children or
supervision.
6. Young children should be supervised to
ensure that they do not play with the blower.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
revolution may
infirm persons
GEA010-1

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
GEB073-1
returns to the "OFF" position when released.
Fig.1
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button, and then release the
switch trigger.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Air volume adjusting dial
cause
Fig.2
Air speed and volume can be adjusted without positive
without
stops by turning the air volume adjusting dial.
To obtain high speed and increase volume, turn the air
volume adjusting dial to the A direction shown in the
figure (for the bigger number). Turn the air volume
adjusting dial to the B direction (for the smaller number)
to obtain low speed and to decrease the air volume.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing the nozzle
Fig.3
Align the pin protruding inside the nozzle with the notch
on the tool, push the nozzle to the blower outlet and
then securely turn the nozzle clockwise.
To remove the nozzle, turn counterclockwise and pull it
out.
Installing the sash nozzle
Fig.4
Sash nozzle is convenient for operation in a sash rail,
corner or tight place between cabinets. Secure the sash
nozzle by inserting it into the nozzle from the back of the
nozzle.
Install the nozzle with the attached sash nozzle.
Fig.5
4