1. Hedge shear blade
2. Hedge shear blade cover
3. Storage case
011044
Chip receiver for hedge trimming (for Hedge
•
Trimmer)
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
Installing or removing hedge shear blades
CAUTION:
Before installing or removing shear blades, always
•
be sure that the tool is switched off and the battery
cartridge is removed.
When replacing the shear blades, always wear
•
gloves without removing blade cover so that hands
and face do not directly contact the blade. Failure to
do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
•
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
Installing the hedge shear blades
Fig.27
Prepare the crank, the undercover and new shear blades.
Fig.28
Adjust the three pin position so that these three pins are
aligned with the basic alignment line on the tool housing.
Fig.29
Fit the crank with its recessed part facing downward onto
the pins. At this time, apply a small amount of grease to
the periphery of the crank using grease that the shear
blades as optional accessory are provided with or that
remains inside gear housing.
Fig.30
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
1
2
base plate of shear blades are positioned in the center of
these overlapped oval holes.
Fig.31
Take out the blade cover from the old shear blades and fit
it onto the new ones for easy handling during the
replacement of blades.
Fig.32
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the base
plate of the shear blades is set in place.
Fig.33
Tighten two screws with a coin firmly.
Fig.34
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
Fig.35
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol
on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
Fig.36
At this time, make sure that the locking lever fits in the
groove in the undercover.
CAUTION:
Never use the tool without installing the undercover
•
on it.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades do not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
16
3
on the
on the locking
on