Operation - Makita DTD137 Bedienungsanleitung

NOTE:
When the LED display goes off, the tool is turned
•
off to save the battery power. To check the
remaining battery capacity, slightly pull the switch
trigger.
The LED display goes off approximately one
•
minute after releasing the switch trigger.
When the tool is overheated, the light blinks for
•
one minute, and then the LED display goes off. In
this case, cool down the tool before operating
again.
When the LED display lights up and the tool stops
•
even with a recharged battery cartridge, cool down
the tool fully. If the status will not change, stop
using and have the tool repaired by a Makita local
service center.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
Fig.8
Use only bits that has inserting portion shown in the
figure.
For tool with shallow bit hole
Use only these type of bit. Follow the
A=12mm
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
A=17mm
To install these types of bits, follow
the procedure (1).
B=14mm
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
011405
Procedure 1
For tool with normal sleeve
Fig.9
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
For tool with one-touch type sleeve
To install the bit, insert the bit into the sleeve as far as it
will go.
Procedure 2
In addition to the procedure(1) above, insert the bit-
piece into the sleeve with its pointed end facing in.
Fig.10
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as far as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook
Fig.11
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.

OPERATION

Fig.12
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Model DTD137
Standard bolt
N m
140
(kgf cm)
(1,428)
120
(1,224)
100
(1,020)
80
(816)
60
(612)
40
(408)
20
(204)
0
014970
8
M16
M14
M16
M12
M14
M10
M12
M8
M10
M8
1.0 2.0 3.0
Fastening time (S)