Other Functions; Factory Settings; Software Version; Language - Nordmende Transita 320 Bedienungsanleitung

9 Other functions

Some system settings are only available in certain playback modes.
To access the advanced functions listed here, the device must be in either DAB or FM mode.

9.1 Factory settings

Follow these steps to reset the factory settings.
Attention: All stored stations and settings will be lost!
> First open the CD compartment.
Press and hold the INFO/MENU and STOP/ENTER buttons on the front panel
>
simultaneously until [Restart] appears on the display. Then the radio
> carries out a new station scan in DAB mode.

9.2 Software version

Under Menu > [SW version] you will see the currently installed software version.

9.3 Language

Under Menu > [Language] you can use the up/down arrow keys to select one of the available
languages. Confirm your selection using the ENTER button.

9.4 Time

The time is usually read or updated automatically in DAB and FM modes. If no time is displayed,
wait a moment while playing a DAB or FM station. If you would like to adjust the time manually,
first switch the radio to standby mode. Now press the CLOCK button on your remote control.
Now you can use the up/down arrow keys to enter the time. Press the CLOCK button again
after each entry to save the entry.
The time is automatically updated and overwritten when a DAB or FMS station with time
synchronization is selected.

9.5 Equalizer

You can select the equalizer by pressing the EQ button. Press the EQ button repeatedly
to run through all the equalizer presets available.
DE
EN
Page 71