Reaching The Decided Room Temperature; Switch Off The Product; Frost Protection Function; Care And Cleaning - Silvercrest SOR 1500 D3 Bedienungs- Und Sicherheitshinweise

Make sure that both temperature control
and heat level switch
"0" respectively .
Connect the product to a grounded mains
socket protected by a residual current circuit
breaker . Ensure that the mains voltage of the
electrical outlet meets the requirement (see
"Technical data" chapter) .
Note: Ensure the mains plug is fully inserted
to the mains socket .
˜ Reaching the decided room
temperature
Set the temperature control
the heat level switch
indicator lights up .
3
When the desired room temperature is
reached, turn the temperature control
gently counter-clockwise until the product
shuts off . A "click" sound is heard and the
power indicator
3
temperature control
room temperature is now retained .
The product automatically cycles on and off
to keep the decided room temperature . The
power indicator
3
off to indicate when the product is heating
up . As long as the heat level switch
to "1"/"2"/"3", the product operates even
when the power indicator
Use the heat level switch
quickly the product shall warm up . To warm
up quickly, set the heat level switch
to "3" .
˜ Switch off the product
Turn the heat level switch
the temperature control
Remove the mains plug from the mains
socket .
2
are set to MIN and
1
to MAX and
2
to "3" . The power
1
2
goes off . Leave the
at the position . The
2
light also cycles on and
is set
1
is off .
3
to select how
1
1
to "0" then turn
1
to MIN .
2
˜ Frost protection function
The frost protection function
automatically controls the product to
keep the room temperature above
7 °C, steps are as follows:
Connect the product to an earthed socket
protected by a residual current circuit
breaker .
Switch on the product by setting the heat
level switch to either "1", "2" or "3" and
1
by setting the temperature control
"MIN" . The product switches on when the
room temperature is approx . 7 °C . As soon
as the room temperature is above 7 °C, the
product automatically switches off again .
Note: The product will switch itself on and off
automatically to maintain a temperature higher
than 7 °C .
˜ Care and cleaning
WARNING!
Remove the mains plug
from the mains socket and leave the product to
cool completely before cleaning .
WARNING!
Never immerse the product,
power cord or mains plug into water .
Use a damp lint-free cloth to clean the
product . Use a mild detergent on the cloth
for stubborn dirt .
Do not use abrasive, aggressive or chemical
cleaning agents . It could damage the surfaces
of the product .
˜ Storage
If the product not to be use for a long period
of time, clean it as described in the section

"Care and cleaning" .

to
2
GB 11