Bestway 58210 Montageanleitung Seite 62

The Comfortable, Affordable, Go-Anywhere Spa!
1
The Lay-Z-Spa™ should not
be setup or left out in
temperatures lower than 4˚C
(40˚F).
Hibernate Function:
11
After 72 hours of operation, the pump will
hibernate and "END" will be display on the
LED. When the pump is hibernating both the
rapid heating and water filtration functions are
disabled. To re-active the pump simply press
any button on the control panel.
10
All Spas require the use
of chemicals in order to
keep the water clear and
safe.
™
™
2
The pump must be tested before
each use. After testing the pump,
be sure to unplug and plug the
pump back in.
12
IMPORTANT NOTICE:
This unit will auto lockout after
5 minutes of inactivity.
To simply place a finger
over function button
for 3 seconds.
9
If the pump not heating properly,
please press the thermal cut-out
manual "Reset" button on
the pump.
Congratulations on the purchase of your new Lay-Z-Spa™.
Before operating the Lay-Z-Spa™ be sure to follow these 13
steps. Damage resulting from misuse is not covered by the
manufacturer's warranty.
MAX
MIN
Water
3
Level
Fill the water level between 4
maximum and minimum
printed on the SPA wall.
13
We recommend you take a shower
before using your Lay-Z-Spa, as
cosmetic products, lotions, and other
residues on the skin can quickly
degrade water quality.
8
Change the Filter Cartridges
regularly
C
B
A Remove 2 Stopper Caps
Ensure water is circulating between
the Spa and the Pump and that the 2
Stopper Caps have been
removed.
5
Be sure to set your desired
6
Check and ensure the Spa and 3
adapters are not leaking.
7
Clean and maintain the Filter
Cartridge regularly.
temperature.
1
S-S-003347