Ironing Instructions - Silvercrest SDMF 1630 A1 Bedienungs- Und Sicherheitshinweise

Filling the water tank 6 : Press the release
¾
buttons 10 . Pull the water tank out of the
product (Fig . B) .
Pour water via the water tank opening
into the water tank . Do not exceed the MAX
marking 8 . Close the water tank opening
Wipe off water splashes . Reinsert the water tank
into the product (Fig . C) . The water clicks into
place audibly .
Draining the water tank 6 : Remove the
¾
water tank . Pour out the water through the water
tank opening
˜ Removing/attaching the brush
(Fig . D)
m
WARNING! Risk of burns! Wait until the
product has cooled down before removing or
attaching the brush 3 .
NOTE: The product can be used with or without
the brush 3 .
Removing the brush 3 : Carefully pull the
¾
brush off the upper bracket .
Attaching the brush 3 : Press the brush
¾
onto the steam nozzles 2 . The upper bracket
must engage .
˜ Steam smoothing clothes
Preparation: Hang the clothes on a clothes
¾
hanger or a rail .
m
ATTENTION! Risk of property damage!
Before steam smoothing: Check the ironing
instructions to determine if the clothes are
suitable for use with this product:

Ironing instructions

Ironing instructions can often be found on a
label sewn to the clothes
5 .
Suitable
Yes
Yes
Yes
No
If there should be no label: First try steam
smoothing on an inconspicuous piece of the
clothes .
m
5
ATTENTION! Risk of property damage!
Do not treat leather, velvet, impregnated furniture
.
or materials that are sensitive to steam .
Do not touch materials that are sensitive to heat
(such as synthetic materials such as polyamide
or rayon) directly with the hot steam nozzles 2 .
Only use the steam smoothing function .
Connect the power plug 9 to a suitable power
¾
socket . The LED 1 lights up .
Wait about 30 seconds until the operating
¾
temperature is reached .
As long as the product has not yet reached
the operating temperature, the LED 1 flashes
slowly .
Ejecting steam: Push in
¾
m
WARNING! Risk of burns!
When steam smoothing, always point the steam
nozzles 2 towards the clothes (Fig . E) .
Never steam smooth clothes while they are
being worn .
Allow the clothes to cool down on a clothes
hanger before wearing them .
Slightly stretch the clothes with one hand . Steam
¾
smooth the clothes by moving over them with
the brush 3 . Keep your hands away from the
steam .
Apply light pressure on the clothes with the brush
¾
3 . Move the brush back and forth in a straight
line .
NOTES:
After washing: Hang up the clothes (e .g . on a
¾
clothes hanger) . The clothes thus dry with fewer
creases .
The product cannot produce strong creases or a
¾
smooth, ironed appearance . For such needs, an
iron is more suitable .
4 .
GB/CY 11