Crumb Tray; Cleaning And Care; Storage; Troubleshooting - Silvercrest SDLT 1500 B2 Bedienungs- Und Sicherheitshinweise

To set up the bread roll rack
push the bread roll rack lever
until it locks into place.
Put the bread rolls on the bread roll rack
and ensure that they do not fall through the
bread roll rack
1
Set the toast setting knob
higher than 2. The toasting intensity depends
on the type of bread rolls.
Press the bread carriage lever
it locks into place. The white indicator on the
stop button lights up.
4
Turn the bread rolls over as soon as the de-
sired reheating time is over and the bread
carriage lever
3
Push the bread carriage lever
it locks into place. The white indicator on the
stop button lights up.
4
Push the bread roll rack lever
return the bread roll rack
position.

Crumb tray

CAUTION! RISK OF BURNS
DUE TO HOT SURFACES! The
crumb tray
face of the device may get hot when the de-
vice is operating.
When toasting, bread crumbs may fall down.
These are then caught in the crumb tray
Remove the crumb tray
to empty it.

Troubleshooting

Malfunction
The device is not working.
The slices of bread are too dark. The toast setting is too high.
10 GB/CY
at full height,
1
right down
9
.
to a setting no
7
down until
3
released.
down until
3
upward to
9
to its original
1
and the outer sur-
8
from the device
8
Cause
The mains plug is not plugged
into a socket.
The device is defective.
Tip the crumbs out before sliding the crumb
tray back into the device.
8
1

Cleaning and care

plug from the socket before cleaning.
mains plug in water or other liquids.
Allow the product to cool down completely.
Do not use abrasive, aggressive or chemical
cleaning agents to clean the surface of the
device.
Use a damp, lint-free cloth to clean the de-
vice. Use a little mild detergent on the cloth
if necessary.
Clean the crumb tray
tergent. Rinse it carefully in clean water and
then dry it up.

Storage

Empty the crumb tray
"Cleaning and care".
Clean the device as described in "Cleaning
and care".
Fully wrap the mains cable in the cable
winder
10
Store the device in a clean and dry place if
. it is not used for a longer period of time.
8
Solution
Connect the mains plug to a mains
socket.
Contact the customer service
department.
Set the toast setting knob
lower setting.
Always remove the mains
Never put the product or the
with a neutral de-
8
as described in
8
under the device.
to a
7